Release notes for Kessler Second Shooter Plus firmware 0.4.8.9

- Fix for erratic velocity in manual mode
- Now allowing 1/10 sec resolution for time lapse delay
- Improved wifi performance when keypad/LCD UI is enabled
- Support added for future firmware updates via kOS
- Powering on while holding SHIFT+ENTER buttons will restore factory default settings.

Release notes for Kessler Second Shooter Plus firmware 0.4.6.1

Features and fixes applied since firmware 0.4.4.1
- Support for calibration limits via LCD/keypad UI
- Adjustable ramping (acceleration) in Manual mode
- Max speed in manual mode = max speed in programmed move
- Fast Mode support (horizontal orientation, agressive gearing)
- Recalc run time on changes to fast/quiet mode
- Faster re-enable of LCD UI on kOS UI disconnect
- L/R UP/DN swap for slave axes
- kOS UDP support (for JogWheel WiFi)
- All motion control now done via trapezoidal mode (support for multiple controlling devices)
- Support for following features in kOS:
-- All variants of rapid/reverse to 1st KF
-- Variable # of live motion loops
-- Pause/resume
-- External trigger
-- Camera Roll/LANC cable
               
Release notes for Kessler Second Shooter Plus firmware 0.4.4.1

Features and fixes applied since firmware 0.4.4.0
- Fixed potential motor runaway if a cable is disconnected

Release notes for Kessler Second Shooter Plus firmware 0.4.4.0

This is the initial public release of Second Shooter Plus firmware
- Compatible with Second Shooter for master/slave configuration
- Maximum photo count of 50,000 for time lapse
- Support for kOS software via USB or wifi
- Quiet mode for reducing motors noise when needed
- External intervalometer supported
- Increased motor speed beyond Second Shooter




